Artikla trenutno ni na zalogi. Spodaj se lahko prijavite in poslali vam bomo obvestilo, takoj ko artikel prispe na zalogo. Obvestilo boste dobili samo za ta artikel.
Za željeni artikel nam pošljite sporočilo/povpraševanje in vas bomo kontaktirali.
Za željeni artikel nam pošljite sporočilo/povpraševanje in vas bomo kontaktirali.
Product details
UMFT230XB-WE breakout module utilizes FT230XQ IC to convert USB to basic UART module. UMFT230XB bridges from USB to UART IC. This hardware is a low cost breakout board form factor that converts USB2.0 full speed to a serial interface and connects the serial signals to a 2.54mm (0.1inch) pitch 10pin female receptacle. The boards do not use a USB connector, but instead the modules plug directly into the USB host connector and the pads of the PCB makes electrical contact with the electrical contacts of the USB connector.
- Single chip USB to asynchronous serial data transfer interface
- Entire USB protocol handled on the chip. No USB specific firmware programming required
- Royalty free VCP and D2XX drivers eliminate the requirement for USB driver development in most cases
- Configurable CBUS I/O pin
- Device supplied preprogrammed with unique USB serial number
- Supports bus powered, self powered and high power bus powered USB configurations
- Integrated power on reset circuit
- Low USB bandwidth consumption
- UHCI/OHCI/EHCI host controller compatible
- USB 2.0 full speed compatible
Specifications
Silicon Manufacturer - FTDI
Silicon Core Number - FT230XB
Kit Application Type - Interface Module
Application Sub Type - USB to UART
Kit Contents - Dev Board FT230XB
Product Range -
Features - Full Speed USB2.0, 3Mbaud UART, 4 Control Bus Lines, Embedded ROM, 3.3V O/P, USB Powered, Wire Ended
SVHC - No SVHC (17-Dec-2015)